The trouble: Ottomans take up space, no room for espresso table. Ripping sixteen" section off birch plywood panel. Marking the core to find where the corners will likely be. Seven kerfs spaced 1/4" aside. Raising blade to leave just 1/8" of fabric. Scariest part! Running the plywood to reduce the kerf. Phew! Chopping the leisure of the kerfs. Scan bend. Set depth of round noticed to almost bite by means of. Plunge reduce. These create house for hidden splines. Test bend. Scrap hardwood ripped to fit in the circular noticed kerf. Chopping out splines. Equipped for the glue up! Apply quite a few glue! Clamp and check for square. Insert splines and let dry for a couple of days. Ancient desk leg, practice adhesive and sandpaper.Superb for cleaning up the inside curves. Fill any left over voids. Sand delicate. No longer unhealthy! Inserting collectively leaves a void. Let’s fix it! Marking so it’ll be flush with the flat surfaces. Reduce out on the bandsaw. Round edges on disc sander. Creating the core strip. Surroundings blade to cut 15 chopping one side. Flip and slice different part. I went as far as needed, killed the table saw and took out the piece as an alternative than run it thoroughly through unsafely. That’ll do. Marking out the profile for a lap joint. Cutting out on the bandsaw. Gluing in position. Apply polyurethane. Line inside of with a slippery fabric. Trim flush with razor blade. It matches! This one matches too! Move two together to add the flush insert. Glamor pictures..